LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2008 >> Vibe Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (Cellular System, Entertainment System & Navigation System) >> Repair Instructions >> Communication Interface Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Communication Interface Module In Vehicle
    GM2014995Courtesy of GENERAL MOTORS CORP.
  1. Position the vehicle communication interface module (3) in the vehicle.
    2. NOTE: Refer to BATTERY DISCONNECT WARNING .
  2. Install the three nuts (2).

    Tighten:  Tighten the nuts (2) to 7.5 N.m (66 lb in).

  3. Connect vehicle communication interface module electrical connectors (1).
    4. Fig 2: Identifying Guides And Communication Interface Module Cover
    GM2014952Courtesy of GENERAL MOTORS CORP.
  4. Engage two guides (2) and install the communication interface module cover (3).
  5. Install the two clips (1).
  6. Connect two vehicle communication interface module electrical connectors (1).
  7. Install the front seat. Refer to Front Seat Replacement - Bucket .
    8. CAUTION: Refer to BATTERY DISCONNECT WARNING .
  8. Connect the battery ground cable.
    9. IMPORTANT: If replacing the vehicle communication interface module, you must reconfigure the OnStar® system.
  9. Reconfigure the OnStar® system. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals