LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> G3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Antilock Brake System With Traction Control System) >> Repair Instructions >> Brake Pressure Modulator Valve Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Pipes At Brake Pressure Modulator Valve
    GM1779018Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the BPMV assembly (1) into the mounting bracket. Secure with two nuts (2) and tighten to 15 N.m (11 lb ft).
  2. Remove the plugs from the brake pipes and connect the brake pipes to the BPMV assembly (1) and tighten to 22 N.m (16 lb ft).
    3. Fig 2: Electronic Brake Control Module & Connector
    GM1779013Courtesy of GENERAL MOTORS CORP.
  3. Connect the EBCM connector (1).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding .
  6. Perform the Diagnostic System Check - Vehicle .
  7. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals