Specifications Index
AVEO & G3 SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT SYSTEM CAPACITIES (V5 SYSTEM) | ||
| Torque | Automatic System FASTENER TIGHTENING SPECIFICATIONS Manual System FASTENER TIGHTENING SPECIFICATIONS |
||
| Axle Nut/Hub Nut | |||
| Front | 221 lb ft (300 N.m) | ||
| Battery | BATTERY USAGE | ||
| Brakes | |||
| Bleeding Sequence | Right Rear, Left Front, Left Rear, And Right Front. See HYDRAULIC BRAKE SYSTEM BLEEDING | ||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drum Brakes | |||
| Service Specifications | DRUM BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERATOR USAGE | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | Serpentine drive belts are not adjustable | ||
| Belt Routing | 1.6L (LXV) See illustration under DRIVE BELT REPLACEMENT | ||
| Engine Cooling | |||
| General Service Specifications | NA | ||
| Radiator Cap Pressure | Specification is stamped on pressure cap | ||
| Thermostat R & I | |||
| 1.4L (LDT) & 1.6L (LXV) | ENGINE COOLANT THERMOSTAT REPLACEMENT (1.4L LDT/1.6 LXV) | ||
| Water Pump R & I | |||
| 1.4L (LDT) & 1.6L (LXV) | COOLANT PUMP REPLACEMENT (1.4L LDT/1.6 LXV) | ||
| Engine Mechanical | |||
| 1.6L (LXV) | |||
| Compression | ENGINE COMPRESSION TEST | ||
| Oil pressure | at least 18.85 psi (130 kPa) at idle with oil temperature greater than or equal to 27°C (80°F). | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive PlateTorque | |||
| 1.6L (LXV) | First step 25.8 ft. lbs. (35 N.m) + an additional 30 degres Final Step + an additional 15 degrees |
||
| Fuel System | |||
| Pressure Specification | 1.6L (LXV) 53-60 psi (365-414 kPa) | ||
| Fuel Pressure Test Procedure | 1.6L (LXV) See FUEL PRESSURE GAGE INSTALLATION AND REMOVAL and FUEL SYSTEM DIAGNOSIS | ||
| Fuel Filter Location | 1.6L (LXV) fuel filter is contained in the fuel sender assembly inside the fuel tank. Some models may have a filter on the frame rail. | ||
| Fuel Filter R & I | 1.6L (LXV) See FUEL FILTER REPLACEMENT and FUEL SENDER ASSEMBLY REPLACEMENT | ||
| Ignition | |||
| Firing Order & Cylinder Identification | |||
| 1.6L (LXV) | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | 1.6L (LXV) Coil on plug | ||
| Ignition Wires (Routing) | 1.4L (LDT) & 1.6L (LXV) Coil on plug | ||
| Spark Plug | |||
| 1.6L (LXV) (Type Woojin NGK - ZFR6U-II) | |||
| Gap | 0.039-0.043 in (1.0-1.1 mm) | ||
| Torque | 18 ft. lbs. (25 N.m) | ||
| Starting | |||
| Starter | NA | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | Aluminum & Steel Wheel 88 ft. lbs. (120 N.m) | ||