Theft Deterrent Scan Tool Data Parameters

Parameter	Operating Conditions	Expected Value	Definition
Ignition is ON, engine OFF, and vehicle is stationary
Auto Learn Counter	-	0 counts	This displays Counts. This is the number of times the auto learn procedure was carried out by the TDM
Auto Learn Timer	-	0:00 mins	This displays minutes. This is the amount of minutes the TDM took to auto learn.
Fleet Vehicle	-	Yes	The scan tool will display whether the vehicle is a fleet car.
Fleet Vehicle	-	No
Learn Coded Key	-	Yes	The scan tool will display whether the module has learned the code of the key in use.
Learn Coded Key	-	No
Ignition Voltage Signal	-	Present	The scan tool displays Present or Not Present. Present is displayed if there is an ignition voltage signal to the TDM.
Ignition Voltage Signal	-	Not Present
Immobilisation	Immobilisation activated	Active	The scan tool displays Active or Inactive to indicate the status of the immobilisation.
Immobilisation	Immobilisation deactivated	Inactive
Immobilizer Programmed	-	Yes	The scan tool will display if the immobilizer is programmed or not.
Immobilizer Programmed	-	No
Master Keys Learned	-	2 counts	The scan tool will display the total number of keys programmed as master keys to the vehicle.
PCM Auto Learn Timer	-	Active	The scan tool displays Active or Inactive. This is the current state of the ECM auto learn timer.
PCM Auto Learn Timer	-	Inactive
PCM Password Learned	-	Enabled	The scan tool displayed whether the fuel enabled password is enabled or disabled to the ECM
PCM Password Learned	-	Disabled
Power Mode	Ignition is in OFF position	Off	This parameter displays Off/Accessory/Run/Crank. This is the status of the system power mode dependent on the ignition position.
	Ignition is in ACC position	Accessory
	Ignition is in RUN position	Run
	Ignition is in CRANK position	Crank
Powertrain DTC	-	Yes	The scan tool displays Yes or No. Yes is displayed if there is a powertrain DTC stored in the ECM or TCM.
Powertrain DTC	-	No
Previous TDM State	-	Learn Keys Standby	This was the last state of the TDM.
	-	Wake up
	-	Monitor Key
Security Code Programmed	-	Yes	The scan tool displays Yes or No. Yes is displayed if a security code is programmed.
Security Code Programmed	-	No
Start Disabled	-	Yes	The scan tool displays Yes or No. Yes is displayed if the starter is disabled.
Start Disabled	-	No
Tamper Status	-	Active	The scan tool displays whether theft is in the tamper state.
Theft Deterrent Module (TDM) State	-	Learn Keys Standby	This was the last state of the TDM.
	-	Wake up
	-	Monitor Key
Telltale Status	-	On	This is the state of the security indicator.
Telltale Status	-	Off	This is the state of the security indicator.
Theft Problem	-	Yes	The scan tool displays Yes or No. Yes is displayed if there is a theft problem.
Theft Problem	-	No
Total Keys Learned	-	2 counts	This displays Counts. This is the number of total keys learned by the TDM.
Transponder Key	-	Present	The scan tool displays Present or Not Present. Present is displayed when a transponder is present. This does not mean that this is a valid or learned transponder, but only that a transponder is present.
Transponder Key	-	Not Present
Valid Key	-	Yes	The scan tool displays Yes if a valid transponder key is present.
Valid Key	-	No