Installation Procedure
- Inspect the EBCM (1) to BPMV (2) mating surfaces and seal.
- Clean the seal surface of the BPMV.
- Install the EBCM (1) to the BPMV (2).
- Install the NEW EBCM to BPMV retaining screws and tighten in sequence to 8 N.m (71 lb in).
- Connect the EBCM electrical connector (1) to the EBCM (3).
- Rotate the EBCM connector tab (2) to the locked position.
- Use the scan tool in order to clear any DTCs.
- Perform the Auto Bleed Procedure. Refer to Antilock Brake System Automated Bleed Procedure .
- If installing a new EBCM, it is necessary to program the EBCM. Refer to Service Programming System (SPS) .
- Perform the System Check-Vehicle. Refer to Diagnostic System Check - Vehicle .
- Re-calibrate the brake pedal position sensor. Refer to BRAKE PEDAL POSITION SENSOR (BPPS) LEARN .
WARNING:
Refer to Brake Fluid Warning
.
WARNING:
Refer to Brake Fluid Irritant Warning
.
CAUTION:
Refer to Adding Fluid to the Brake System Caution
.
CAUTION:
Refer to Brake Fluid Effects on Paint and Electrical Components Caution
.
NOTE:
The seal is not available as a spare part and the mating surfaces cannot be mechanically reworked. If the seal or mating surfaces are damaged the EBCM/BPMV assembly must be replaced.
NOTE:
Make sure the coils for the solenoid valves are aligned correctly. If they are not correctly aligned, the EBCM (1) must be replaced.
NOTE:
Make sure the contact pins of the hydraulic pump are aligned correctly.
CAUTION:
Refer to Fastener Caution
.
CAUTION:
To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.