Test Mode 2

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

11. Remove the MPCS service connector from the under-dash fuse/relay box MICU service check connector socket for 5-10 seconds, then re-insert it to enter Mode 2. When the system enters Mode 2, the ceiling light flashes two times quickly and then goes off.
NOTE: If the MPCS service connector is disconnected for too short or too long of a time, or the ignition switch is turned to LOCK (0), the system returns to Test Model.

12. The following tables list the circuits that can be checked in Test Mode 2. Operate the switch that is most closely related to the problem. If the circuit is OK, the ceiling light will blink once. If the circuit is faulty, there will be no indication.

MICU

MICU SPECIFICATIONS

Item

Brake pedal position switch

Driver's door switch

Driver's rear door switch

Trunk lid/Tailgate latch switch

Driver's rear door lock knob switch (UNLOCK)

Windshield wiper switch (LOW)

Windshield wiper switch (HIGH)

Windshield wiper switch (INT)

Windshield wiper switch (MIST)

Rear wiper switch

Windshield washer switch

Rear washer switch

Wiper intermittent dwell time controller

Turn signal switch (LEFT)

Turn signal switch (RIGHT)

Hazard warning switch

Headlight switch (OFF)

Headlight switch (PARKING)

Headlight switch (HEADLIGHT)

Headlight switch (High Beam)

Headlight switch (PASSING)

Trunk handle switch

A/C pressure switch/Thermal protector

Transmission range switch (P)

Ignition key cylinder switch

Security hood switch

Back-up light switch

Windshield wiper motor PARK switch

Front passenger's door switch

Passenger's rear door switch

Passenger's rear door lock knob switch (UNLOCK)

Audio unit or Audio-navigation unit

Driver's door lock switch (UNLOCK)

Driver's door lock switch (LOCK)

Driver's door lock knob switch (UNLOCK)

Driver's door lock knob switch (LOCK)

Driver's door key cylinder switch (UNLOCK)⁽¹⁾

Driver's door key cylinder switch (LOCK)⁽¹⁾

Front passenger's door lock knob switch (UNLOCK)

⁽¹⁾	A second key is necessary to check the key cylinder inputs. Be sure to rotate the key cylinder switch two times to each position (lock and lock, unlock and unlock) to ensure the door lock knob switch is in the appropriate position.

Does the ceiling light work properly in all switch positions?

YES -Go to function and input test for the system related to the failure.

NO -Repair the open, short, or replace the faulty switch.