LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Yaw Rate Sensor
    GM2017689Courtesy of GENERAL MOTORS CORP.
  1. Install the yaw rate sensor (1).
    2. Fig 2: View Of Yaw Rate Sensor & Nuts
    GM2017685Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the yaw rate sensor nuts (1).

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Connect the yaw rate sensor electrical connector.
  4. Carefully position the floor carpet to the vehicle floor.
  5. Install the right side front carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement (Coupe) or Front Side Door Opening Floor Carpet Retainer Replacement (Sedan) .
  6. Install the right front seat. Refer to Front Seat Replacement - Bucket .
  7. Install a scan tool.
  8. Using the special functions menu on the scan tool, perform the steering angle sensor calibration. Refer to Control Module References .
  9. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals