Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Torrent and 2006 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: SIS Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Remove any dirt, grease, or other contaminants from the mounting surface.
Connect the SIS electrical connector and insert into the connector position assurance (CPA) to secure.
Place the SIS through the access hole in the lock pillar.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Slide the module down and locate the captured fastener in the key slots of the lock pillar.
Tighten: Tighten the fastener to 10 N.m (89 lb in).
Install the center pillar lower molding. Refer to Garnish Molding Replacement - Center Pillar Lower in Interior Trim.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or to SIR Disabling and Enabling Zone 6 .