Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X5 harness connector at the BCM.
- Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 5 and ground.
- If the test lamp illuminates, test the control circuit for a short to voltage.
- Ignition ON, connect a 3A fused jumper wire between the control circuit terminal 5 and B+. Verify the auxiliary stop lamps illuminate.
- If the stop lamps do not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the underhood fuse block.
- If all circuits test normal, replace the BCM.