Electronic Brake Control Module Programming and Setup

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replacement, the following procedures must be performed:

* EBCM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning).
* Revise the yaw rate calibration using the Scan Tool yaw rate recalibration function.
* Revise the tire calibration using the Scan Tool Tire Size calibration function.

Yaw Rate Sensor/Lateral Accelerometer Replacement

Note: Be sure the shift lever is in P (for automatic transaxle model) or in neutral and the parking brake is applied (for manual transaxle model).

If the yaw rate sensor/lateral accelerometer is replaced, the following procedures must be performed:

* Revise the yaw rate recalibration using the Scan Tool yaw rate recalibration function.
* Revise the tire calibration using the Scan Tool Tire Size calibration function.