LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2010 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System & Fuel System - 2.4L - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: CMP Sensor & Bolt
    GM1578483Courtesy of GENERAL MOTORS CORP.
    NOTE: Inspect the CMP sensor for damage, replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt and tighten to 10 N.m (89 lb in).
    4. Fig 2: Engine Wiring Harness Electrical Connectors
    GM1890093Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (7) to the intake CMP sensor (6).
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals