Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the theft deterrent module (TDM).
- Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the ground circuit terminal 3 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
- If the test lamp did not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
- If the circuits test normal, replace the TDM.