Removing And Installing Oil Protection Tube - Engine Installed: Installation

INSTALLING PROCEDURE OF OIL PROTECTION TUBE

No.

Procedure

Instructions

5⁽¹⁾

Pulling off oil protection tube

Fit washer (approx. 40 mm) and hexagon nut (M10) on the threaded rod. Press oil protection tube outward using two mounting levers, always using a suitable wooden support.

6⁽¹⁾

Fitting oil protection tube

Fit new sealing rings and coat with tire mounting paste. Using the pressure piece (special tool 9605/1) and hand pressure piece (special tool 9604), manually press in the oil protection tube as far as it will go.

Fitting spark plug

Fit spark plug with the prescribed spark-plug wrench. Tightening torque 25 5 Nm (19 3.5 ft.lb)

Fitting ignition coil

Tightening torque 10 Nm (7.5 ft.lb)

⁽¹⁾	For explanation see Figure.