Ignition Control Module: Service and Repair

WM 282020 Removing and installing bar ignition modules

Tools





Technical values





Preliminary work

1. Switch ignition off and remove ignition key
2. Separate the six bar ignition modules from the wire harness. To do this, press the connectors down slightly, release and remove them using the assembly tool T10118 or a suitable aid (e.g. an angled piece of wire). -1-





Removing cable plugs

Information

Component overview





Ignition system





Installing bar ignition modules

1. Install the plug coils. When doing so, make sure that the smooth surface is pointing upwards. An audible click indicates that they are installed correctly.





Installing plug coils

Subsequent work

1. Reconnect the bar ignition modules. The connectors must lock with an audible click. -arrow-





Connecting bar ignition modules