Preparing Spring Strut Mount For Installation

Cut reinforcement in area -Arrows- leaving an overlap of 30 mm over the remaining piece.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Reinforcement
Fit in and secure reinforcements.
1. 2.1 Tack-weld upper part -1- and lower part -2- of reinforcement -Arrows- .
Remove reinforcements.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Reinforcements

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Reinforcements
1. 3.1 Resistance spot-weld the marked area
Prepare wing bracket for welding.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Wing bracket
Prepare reinforcement for bonding and welding.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Reinforcements
Drill holes for plug-welding in the marked areas -A- on the spring strut mount using a drill bit with a diameter of > Diameter 8, 0 mm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Spring strut mount

Drill holes for plug-welding in the marked areas -A- on the lower part of the plenum panel using a drill bit with a diameter of > Diameter 8.0 mm bohren.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lower part of plenum panel

Orange	Resistance spot-welding
Green	Resistance spot-welding + bonding
Red	Plug-welding/apply a full weld using inert gas without bonding

Prepare wiper holders for resistance spot-welding on the marked surfaces.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Wiper holder