LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 1992 >> 9000 S, Automatic >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - System/Component Tests >> Ignition System >> Timing Control Systems >> Knock Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knock Sensor

  1. Connect timing light. With engine running at a fast idle, tap cylinder head with a plastic mallet. If timing retards, knock sensor is okay. If timing does not retard, turn ignition switch off. Go to step 2) for 900 Series or to step 4) for 9000 Series.
  2. On 900 Series, locate knock sensor under intake manifold. Unplug connectors from sensor and ignition ECU. Check Green wire for continuity between harness connector and ignition ECU pin No. 13. Also check Green wire for short to ground, to Brown wire or to shield.
  3. Check Brown wire for continuity between harness connector and ignition ECU pin No. 12. Also check Brown wire for short to ground, to Green wire or to shield. Ensure there is continuity between shield and ground. Replace wire assembly if defective. Go to step 6).
  4. On 9000 Series, locate knock sensor under intake manifold. Unplug connectors from sensor and ignition ECU. Check Gray wire for continuity between harness connector and ignition ECU pin No. 11. Also check Gray wire for short to shield or to ground.
  5. Check shield for continuity between sensor harness connector and ignition ECU pin No. 30. Check shield for short to ground. Replace wire assembly if defective.
  6. Temporarily, replace knock sensor with a known good one. Repeat step 1). If timing still does not retard, reinstall original sensor and replace ignition ECU.
scientia non olet · About LEMON Manuals