TRIONIC Ignition System
CAUTION:
When performing the following step, position Ignition Coil Module (ICM) with coils and spark plugs downward.
NOTE:
Ignition Coil Module (ICM) may also be referred to as Ignition Discharge Module (IDM).
- Disconnect Ignition Coil Module (ICM) 10-pin connector. Connect test light between connector terminal No. 6 and battery voltage. See Fig 1 . If test light comes on, go to next step. If test light does not come on, repair wiring. See L - WIRING DIAGRAMS article in this section.
- Connect test light between connector terminal No. 10 and ground. Using scan tool, activate one ignition coil. If test light comes on, go to next step. If test light does not come on, check main relay. See RELAYS in I - SYSTEM/COMPONENT TESTS article in this section.
- Remove Ignition Coil Module (ICM). Insert spark plug into each spark plug receptacle. Ground spark plugs with Cable (86 10 867 ). Using scan tool, activate each ignition coil. Check for spark at each spark plug. Repeat procedure if necessary. If any coil is not operating, replace ICM. If any coil is operating, replace spark plug and attempt to start engine. If engine does not start, fault is not in ignition system.