Gate programming and Canada programming

The remote control may stop transmitting during programming. If so, continue to hold the button on the rearview mirror and release and press the button on the remote control every other second until programming is completed.

The LED will flash slowly at first and then rapidly. The rapidly flashing LED indicates that programming is complete and that you can release the buttons.

IMPORTANT: Turn off the switch for the garage door or gate (you can also ensure that the remote control is out of range) while programming the gate to prevent causing damage to the electric motor.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) must accept any interference received, including interference that may cause undesired operation. WARNING: The transmitter has been tested and complies with the rules of FCC and Industry Canada. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.