Reprogramming a button: Notes

1. Turn the ignition ON.
2. Press and hold the desired button on the rearview mirror for the entire programming procedure.
3. The LED will start to flash slowly after 20 seconds.
   Fig 1: Identifying LED Flashes

   Courtesy of SAAB-SCANIA OF AMERICA, INC.
4. Hold the garage door remote control 3-7 cm from the rearview mirror and press the button on the remote control.
   Fig 2: Holding Garage Door Remote Control From Rearview Mirror

   Courtesy of SAAB-SCANIA OF AMERICA, INC.
5. Reprogramming is complete when the LED starts to flash rapidly.

   The previous frequency is now erased and replaced by the new one. Reprogramming one button does not affect the other buttons.

Complete erase 

1. Turn the ignition ON.
2. Press and hold buttons 1 and 3 simultaneously for 20 seconds. Confirmation is provided by the LED flashing rapidly for 10 seconds.
   Fig 3: Identifying LED Flashes

   Courtesy of SAAB-SCANIA OF AMERICA, INC.
3. A complete erase deletes the frequencies from all three buttons. It is not possible to erase the memory of a single button.