Body Control Module: Specifications

Test Readings, BCM

Scope








The following information contain values and instructions for measuring signals and levels on BCM.

Remember:
^ Note the test conditions and use common sense when assessing the test results.
^ First check that the control module has a power supply and is grounded.
^ Then check all sensor inputs and signals from other systems.
^ Finally, check the control module outputs. Remember that the test reading does not indicate whether the actuator works.
^ If any reading is not OK, consult the wiring diagram to trace which leads, connectors or components should be checked more thoroughly.
^ The specified values refer to a calibrated Fluke 88/97.
^ Test readings % (+) and ms (+) show the signal's pulse ratio and pulse length, respectively. A test instrument that can measure pulse ratio and pulse width must be used. The sign indicates the positive trigger pulse, TRIG+.

Connection K78





NOTE: All units connected to the I and P-buses send out signals.

Part 1:

Part 2:

Part 3:

Part 4:

Part 5:

(*) All connected control modules send out voltage.

Connection K16

NOTE: All units connected to the I and P-buses send out signals.