Installation Procedure

Install the ORVM assembly to the door. Ensure that the retaining clip is fully seated.

Fig 1: Removing/Installing Orvm & Retaining Bolts
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .
Install the 3 ORVM retaining bolts.
Tighten: Tighten the bolts to 10 N.m (88 lb in).
Install the side door insulator.

Fig 2: Removing/Installing Side Door Insulator
Courtesy of GENERAL MOTORS CORP.
Install the ORVM harness to the door.
Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .