LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 2007 >> 9-7X 4.2i >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Turn Signal Multifunction Switch Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the turn signal and multifunction switch assembly.
    Fig 1: Removing/Installing Turn Signal Switch Assembly
    GM761439Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.
    NOTE: Refer to Fastener Notice .
  2. Secure by using 2 pan head tapping screws.

    Tighten: 

    • Tighten the screw on the top of the column to 3 N.m (27 lb in).
    • Tighten the screw on the side to 7 N.m (62 lb in).

  3. Connect the connectors to the turn signal and multifunction switch assembly.
  4. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals