Specifications Index
9-3 SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TIGHTENING TORQUE | |
| Axle Shaft Hub Nut | 170 ft. lbs. (230 Nm) | |
| Battery | SPECIFICATIONS | |
| Brakes | ||
| Bleeding Sequence | BLEEDING THE BRAKE SYSTEM | |
| Disc Brakes | BRAKE PADS | |
| Torque | TIGHTENING TORQUES | |
| Charging | ||
| Generator | SPECIFICATIONS | |
| Torque | NA | |
| Drive Belts | ||
| Adjustment | DRIVE BELT, AUXILIARY ASSEMBLY (POLY-V) | |
| Belt Routing | DRIVE BELT, AUXILIARY ASSEMBLY (POLY-V) | |
| Engine Cooling | ||
| General Service Specifications | SPECIFICATION | |
| Radiator Cap Pressure | 20-22 psi (1.4-1.5 bar) | |
| Thermostat R& I | THERMOSTAT | |
| Water Pump R & I | COOLANT PUMP | |
| Engine Mechanical | ||
| Compression | ENGINE COMPRESSION TEST | |
| Oil Pressure | OIL PRESSURE | |
| Overhaul | SPECIFICATIONS | |
| Torque | TIGHTENING TORQUE | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel | 48 ft. lbs. (65 Nm) + 40° | |
| Fuel System | ||
| Fuel Filter Location | Located in fuel pump. | |
| Fuel Filter R & I | See FUEL PUMP (2WD) or FUEL PUMP (4WD) | |
| Pressure Release Procedure | Remove fuse No. 2 in the main fuse box in front of the battery for fuel pump while engine is running. Switch off ignition once engine stops. Refit fuse. | |
| Pressure Specifications | 43 psi (3.0 bar) | |
| Fuel Pressure Test Procedure | NA | |
| Ignition | ||
| Firing Order | FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Routing) | NA | |
| Spark Plugs | ||
| Type | NGK PFR 6T-10G | |
| Gap | .039" (1.00 mm) | |
| Torque | 21 ft. lbs. (28 Nm) | |
| Starting | ||
| Starter | SPECIFICATIONS | |
| Torque | See specific procedure under REPAIR INSTRUCTIONS . | |
| Wheel Alignment | ||
| Adjustment Specifications | WHEEL GEOMETRY | |
| Torque | TIGHTENING TORQUES | |
| Wheel & Tire | ||
| Wheel Stud Torque (Aluminum) | 81 ft. lbs. (110 Nm) | |
| Wheel Stud Torque (Steel) | 37 ft. lbs. (50 Nm) +90°, +90°, max. 81 ft. lbs. (110 Nm) | |