LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2002 >> SC2 Automatic, MP6 >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (HVAC Systems - Automatic) >> Repair Instructions >> Blower Motor Control Processor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor Control Module Electrical Connector
    GM295319Courtesy of GENERAL MOTORS CORP.
  1. Remove the I/P lower insulator panel - RH. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
    2. CAUTION: Unplug the blower motor before removal. Blower motor case contact with any ground may start the fan and cause personal injury.
  2. Disconnect the blower motor control module electrical connector.
    3. Fig 2: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the blower motor control module electrical connector from the blower motor.
    4. Fig 3: Rear Blower Motor Control Module & Retaining Screw
    GM295320Courtesy of GENERAL MOTORS CORP.
  4. Loosen the blower motor control module forward two retaining screws (nearest the dash mat) approximately 5 mm (0.197 in).

    The control module is slotted at the forward retaining locations.

  5. Remove the rear blower motor control module retaining screw.
  6. Tilt down the rear of the blower motor control module.
  7. Remove the blower motor control module from the HVAC module.
scientia non olet · About LEMON Manuals