LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2004 >> Vue Base, 2.2 D, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Wiper Motor
    GM897834Courtesy of GENERAL MOTORS CORP.
  1. Install the wiper motor to the transmission.
  2. If the wiper module bushings were replaced, install the rubber grommet first, then the steel bushing.
  3. Install the wiper motor to the plenum area.
  4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the wiper motor bolts.

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

  6. Connect electrical connector to wiper motor.
  7. Install the rear hood seal. Refer to Seal Replacement - Hood Rear in Body Front End.
  8. Install air inlet grill. Refer to Air Inlet Grille Panel Replacement .
  9. Install wiper arm. Refer to Wiper Arm Replacement .
  10. Inspect the wiper/washer system for proper operation.