LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2004 >> Vue Red Line, AWD >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Lock Housing Bolts
    GM928840Courtesy of GENERAL MOTORS CORP.
  1. Pre-assemble the lock housing and multifunction lever bracket. Hand-tighten the bolts, leaving approximately 3.2 mm (0.125 in) gap at the bolt ends.
    2. IMPORTANT: Ensure that the lock tab fully engages into the column slot.
  2. Slide the bracket onto the column.
  3. Hand-tighten the lower bolt until snug.
  4. Hand-tighten the upper bolt until snug.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the lower bolt.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in)

  6. Tighten the upper bolt.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in)

    7. Fig 2: View Of Ignition Housing Electrical Connectors
    GM928832Courtesy of GENERAL MOTORS CORP.
  7. Connect the ignition housing electrical connectors.
    8. Fig 3: View Of Multifunction Lever
    GM928835Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that both locking tabs are seated.
  8. Install the multifunction levers.
  9. Install the upper and lower shrouds. Refer to Steering Column Trim Covers Replacement .
  10. Install the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
  11. Install the steering wheel. Refer to Steering Wheel Replacement .
  12. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals