LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Ion Red Line >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
  2. Install the EBCM (1) to the BPMV (2). Use care when aligning the EBCM (1) to the BPMV electrical terminals (3).
    3. Fig 1: View Of EBCM & BPMV
    GM891775Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 4 EBCM-to-BPMV retaining bolts (1). Tighten the bolts in a criss-cross pattern.

    Tighten:  Tighten the bolts to 3 N.m (27 lb in).

    4. Fig 2: View Of EBCM-To-BPMV Retaining Bolts
    GM891773Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the EBCM.
    5. Fig 3: View Of EBCM Electrical Connector
    GM890987Courtesy of GENERAL MOTORS CORP.
  5. Turn the ignition switch to the ON position. DO NOT start engine.
  6. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals