LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Controls - Introduction) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Make sure the interconnect and seal are lined up before module installation.
  1. Install the ignition control module in the ignition coil housing.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the ICM retaining screws.

    Tighten:  Tighten the retaining screws to 1.5 N.m (13 lb in).

    3. Fig 1: View Of ICM
    GM783965Courtesy of GENERAL MOTORS CORP.
  3. Connect the ICM harness connector.
  4. Install the accelerator cable bracket.
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the accelerator cable bracket bolt.

    Tighten:  Tighten the retaining screws to 10 N.m (18 lb in).

  6. Install the accelerator cable to the bracket.
scientia non olet · About LEMON Manuals