LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Controls - 3.4L - Introduction) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ignition control module on the bracket.
    2. Fig 1: Removing/Installing Coil Assemblies
    GM28342Courtesy of GENERAL MOTORS CORP.
  2. Install the coils to the ignition control module.
  3. Reinstall the fasteners securing the ignition control module assembly to the engine.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Reinstall the screws.

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  5. Connect the spark plug wires as noted during removal.
  6. Connect the electrical connectors to the ignition control module.
scientia non olet · About LEMON Manuals