LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Controls - 3.4L - Introduction) >> Repair Instructions >> Powertrain Control Module (PCM) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of PCM
    GM512028Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the PCM electrical connectors.

    Tighten:  Tighten the PCM electrical connector screws to 8 N.m (71 lb in).

  2. Install the PCM into the air cleaner assembly.
  3. Install the air cleaner assembly cover.
  4. Tighten the air cleaner assembly cover retainers.
  5. Install the left sheet metal diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal - Left in Body Front End.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (LA1) in Engine Electrical.
  7. If a new PCM is being installed, program the EEPROM. Refer to Control Module References in Computer/Integrating Systems.
scientia non olet · About LEMON Manuals