Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Separating/Installing EBCM From BPMV

Courtesy of GENERAL MOTORS CORP.

Clean the BPMV surface with alcohol using a clean rag.
Install the EBCM (1) to the BPMV.

NOTE: Refer to Fastener Notice .

Install the 6 screws that attaches the EBCM to BPMV.
Tighten:
- Tighten the top 4 mounting screws to 5 N.m (44 lb in). Tighten screws in an X pattern.
- Tighten the bottom 2 mounting screws to 5 N.m (44 lb in).
Connect the pump motor connector to the bottom of the EBCM.

Fig 2: Identifying Electronic Brake Control Module

Courtesy of GENERAL MOTORS CORP.

Connect the electrical harness connector (2) to the EBCM.
Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
If a new EBCM was installed, the EBCM must be programmed. Refer to Control Module References .
Turn the ignition switch to the RUN position, do not start engine.
Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle .