Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Turn the ignition switch to the OFF position.
Remove the air cleaner assembly from the engine compartment. Refer to Air Cleaner Assembly Replacement .

Fig 1: Identifying Electronic Brake Control Module

Courtesy of GENERAL MOTORS CORP.

Disconnect the electronic brake control module (EBCM) harness connector (2).
Brush off any dirt/debris that has accumulated on the assembly.
Disconnect the pump motor connector at the bottom of the EBCM.

IMPORTANT:

Do not damage the seal by prying the EBCM from the brake pressure modulator valve (BPMV).
Do not damage the solenoid valves while removing the EBCM from the BPMV.

Fig 2: Removing EBCM To BPMV Screws

Courtesy of GENERAL MOTORS CORP.

Remove the EBCM to BPMV screws.

Fig 3: Separating/Installing EBCM From BPMV

Courtesy of GENERAL MOTORS CORP.

Separate the EBCM from the BPMV by gently pulling apart until separated (1).