LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Control System - 3.5L (Lx9) - Introduction) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing 4 Screws Securing Ignition Coil And Module Assembly To Bracket
    GM1238999Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil and module assembly to the bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition coil and module assembly screws.

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Connect the spark plug wires as noted during the removal.
scientia non olet · About LEMON Manuals