LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Engine Control System - 2.2L (L61) - Introduction) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Accelerator Pedal Position Sensor Electrical Connector
    GM1544734Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator assembly (2) to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the accelerator mounting bolts (1) to the accelerator bracket.

    Tighten:  Tighten the accelerator pedal nuts to 10 N.m (89 lb in).

  3. Connect the accelerator pedal position sensor electrical connector.
  4. Confirm that the accelerator sensor connector locking clip is fully secured.
  5. Verify the operation of the accelerator pedal.
scientia non olet · About LEMON Manuals