LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Module Support Bracket Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing 3 Wiper Motor Module Support Bracket Screws
    GM1206999Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor module support bracket to the wiper motor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the wiper motor module support bracket screws.

    Tighten:  Tighten the screws to 5.5 N.m (49 lb in).

  3. Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
  4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  5. Cycle the wiper drive system. Turn off the wiper drive system at the park position to ensure proper positioning of the wiper arms upon installation.
  6. Install the wiper arms. Refer to Wiper Arm Replacement .
scientia non olet · About LEMON Manuals