LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2006 >> Ion Red Line >> Repair and Diagnosis (Single Page) >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Diagnostic Information and Procedures >> Power Windows Inoperative - All (Sedan) >> Circuit/System Testing >> Passenger Power Window Inoperative
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Passenger Power Window Inoperative

  1. Ignition OFF, disconnect the harness connector at the appropriate passenger Window Switch.
  2. Ignition OFF, test for less than 1.0 ohm of resistance between the control circuit terminal D and ground.
    • If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the Driver Window Switch.
  3. Ignition OFF, test for less than 1.0 ohm of resistance between the control circuit terminal H and ground.
    • If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the Driver Window Switch.
  4. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal A and ground.
    • If the test lamp does not illuminate and the Lockout Switch is CLOSED, test the B+ circuit for an open/high resistance.
  5. Connect a test lamp between the control circuit terminal D and control circuit terminal H.
  6. Ignition ON, command the appropriate passenger window UP and DOWN by pressing the appropriate window control on the Driver Window Switch. The test lamp should illuminate during either of the commands.
    • If the test lamp is always OFF, test for a short to ground on either control circuit. If all circuits test normal, test or replace the Driver Window Switch.
  7. Ignition OFF, reconnect the appropriate passenger Window Switch.
  8. Ignition OFF, disconnect the harness connector at the appropriate passenger Window Motor.
  9. Ignition OFF, test for less than 1.0 ohm of resistance between the control circuit terminal A and ground.
    • If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the appropriate passenger Window Switch.
  10. Ignition OFF, test for less than 1.0 ohm of resistance between the control circuit terminal B and ground.
    • If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the appropriate passenger Window Switch
  11. Connect a test lamp between control circuit terminal A and control circuit terminal B.
  12. Ignition ON, command the appropriate passenger window UP and DOWN by pressing the appropriate passenger Window Switch. The test lamp should turn ON when commanding the UP and DOWN states.
    • If the test lamp remains OFF during either of the commands, test for a short to ground on either control circuit. If the circuits test normal, test or replace the appropriate passenger Window Switch.
  13. If all circuits test normal, test or replace the appropriate passenger Window Motor.
scientia non olet · About LEMON Manuals