Test Description
WARNING: This page is about a different car, the 2004 Saturn Ion Red Line, 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
The number(s) below refer to the step number(s) on the diagnostic table.
- 2: Confirms if the scan tool can monitor the on and off the Traction Control Switch LED indicator.
- 4: Verify if the circuits going to the Traction Control Switch is at fault.
Traction Control Indicator Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: Body Control System Connector End Views in Body Control System |
|||
| 1 | Did you perform the Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - ABS |
| 2 |
|
Go to Step 3 | Go to Step 4 |
| 3 | Test the traction control indicator control circuit for a short to voltage. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 4 | Test the Traction Control Switch Signal circuit or Traction Control Switch for an open. Did you find and correct the condition? |
Go to Step 6 | Go to in Testing for Intermittent Conditions and Poor Connections Wiring Systems |
| 5 | Replace the BCM. Refer to Traction Control Switch Replacement . Is the replacement complete? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |