Installation Procedure

Fig 1: Locating Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Align the module with the seat base and connect the electrical connectors to the module.

Fig 2: Removing & Installing Fasteners For Module Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the module bracket and secure with fasteners.
Tighten: Tighten the fasteners to 2 N.m (18 lb in).
Test the module for proper operation.
Install the upper seat trim. Refer to Sit-N-Lift Upper Trim Replacement .
Refer to Control Module References for programming and setup information.