Ignition 1 Relay: Notes

The relay uses a Hot At All Times B+ power source derived from the underhood electrical center. The ignition 1 relay supplies a power signal to the following circuits when the Run or Crank power mode is selected:

• AC clutch relay
• ABS STG angle sensor
• Antilock brake system (ABS) yaw sensor
• Auxiliary power drop connector
• Crank relay
• Cruse control switch
• Electronic brake control module (EBCM)
• Engine control module (ECM)
• HVAC module
• Ignition control module (ICM)
• Instrument panel cluster (IPC)
• Sensing and diagnostic module (SDM)
• Transmission solenoid circuit