LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Data Communication System >> Repair Instructions >> Body Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of BCM
    GM877750Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the BCM to the vehicle and install the retaining nuts.

    Tighten:  Tighten the nuts to 10 N.m (88 lb in).

    2. Fig 2: View Of BCM I/P Wiring Harness Connectors
    GM877747Courtesy of GENERAL MOTORS CORP.
  2. Connect the large I/P wiring harness connector (2) to the BCM.
  3. Connect the small I/P wiring harness connector (1) to the BCM.
    4. Fig 3: View Of BCM Body Harness Connectors
    GM877745Courtesy of GENERAL MOTORS CORP.
  4. Connect the large body wiring harness connector (2) to the BCM.
  5. Connect the small body wiring harness connector (1) to the BCM.
  6. Connect the OnStar® connector.
    7. Fig 4: View Of Center Support Bracket
    GM877820Courtesy of GENERAL MOTORS CORP.
  7. Pull back the carpet and position the center support bracket into position.
  8. Install the center support bracket nuts.

    Tighten:  Tighten the nuts to 10 N.m (88 lb in).

    9. Fig 5: View Of Wiring Harness Center Support Bracket
    GM877821Courtesy of GENERAL MOTORS CORP.
  9. Install the wiring harness rosebud to the center support bracket.
  10. Install the front floor console. Refer to Front Floor Console Replacement .
  11. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  12. Program a new or a remanufactured BCM. Refer to Control Module References .
scientia non olet · About LEMON Manuals