DTC Set In Amplifier
WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
- With the scan tool, verify the DTC is set by the amplifier.
- Ignition OFF, disconnect the suspect speaker. Test for 1-50 ohms across the speaker terminals.
- If not within the specified range specified range replace the suspect speaker.
- Disconnect the suspect audio amplifier harness connector.
- Test for less than 1 volt on both of the suspect speaker output circuits.
- If greater than 1 volt repair short to voltage.
- Test for infinite resistance between both of the suspect speaker output circuits and ground.
- If resistance is less than specified value, repair short to ground.
- Test for less than 1 ohm between suspect speaker output circuits amplifier harness connector and the suspect speaker harness connector.
- If greater than specified value repair open or high resistance.
- If all circuits test normal, replace the amplifier.