LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Relay 3.9 W >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Lighting System) >> Diagnostic Information and Procedures >> Turn Signal Lamps and/or Indicators Inoperative >> Circuit/System Testing >> Turn Signal Multifunction Switch Circuit Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Turn Signal Multifunction Switch Circuit Testing

WARNING: This page is about a different car, the 2007 Saturn Outlook. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the turn signal multifunction switch.
  2. Ignition ON, install a test lamp between the turn signal voltage supply circuit and ground. The test lamp should flash ON and OFF.
    • If the test lamp does not flash, test the voltage supply circuit for a short to ground or an open/high resistance.
  3. Install a 3-amp fused jumper wire between the voltage supply circuit and the turn signal circuit. Verify that the proper turn signal lamps are ON.
    • If the turn signals are not ON, test the signal circuit of the turn signal multifunction switch for a short to voltage, short to ground or an open/high resistance.
  4. If all circuits test normal, test or replace the turn signal multifunction switch.
scientia non olet · About LEMON Manuals