LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Vue Base, 2.2 D, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1003 (Object Detection System) >> Diagnostic Information and Procedures >> Information Center Telltale Malfunction >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the RPA display.
  2. Connect a 10A fused jumper wire between the 12 volt supply circuit terminal A and B+.
  3. Connect a 10A fused jumper wire between the control circuit terminals listed below and ground:
    • Left amber LED control circuit terminal B
    • Center amber LED control circuit terminal C
    • Red LED control circuit terminal D
  4. Verify that the appropriate LED illuminates.
    • If the component does not perform as specified, replace the RPA display.
scientia non olet · About LEMON Manuals