LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2007 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (HVAC Systems - Manual) >> Repair Instructions >> Recirculation Actuator Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the recirculation actuator, aligning the slots in the electric actuator drive to the flats on the shaft.
  2. Align the locating hole to the alignment pin on the HVAC module assembly.
  3. Slide the actuator drive completely onto the shaft, with the mounting holes flush with the mounting screw holes on the HVAC module assembly.
    4. Fig 1: View Of Recirculation Actuator
    GM1194922Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws to the recirculation actuator.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  5. Connect the electrical connector to the recirculation actuator.
  6. Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
  7. Install the right/I/P insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
  8. Calibrate the actuator. Refer to Re-Calibrating Actuators .
scientia non olet · About LEMON Manuals