Remote Control Door Lock Receiver Replacement (Copy and Paste TPM Information)

This procedure will learn the TPM information to the new RCDLR using the Copy and Paste function on the scan tool. The procedure will extract the TPM Tire Type information as well as the sensor data from the existing RCDLR prior to its replacement and store this information in the scan tool. After RCDLR replacement, the tire type and sensor data stored in the scan tool is written to the new RCDLR, negating the need to perform the tire type setup and sensor learn procedure.

This procedure should be considered as the first programming choice when replacing an RCDLR. The Copy and Paste procedure eliminates the possibility of incorrectly inputting the tire type or learning stray TPM sensors.

IMPORTANT: This step must be performed prior to the removal or replacement of the old RCDLR.
1. Using a scan tool, navigate to the Copy and Paste TPM Information procedure and copy the existing TPM information from the RCDLR using the outline below. Follow the on-screen instructions after selecting Step 1:
   • Vehicle Control Systems
   • Module Setup
   • Remote Control Door Lock Receiver
   • Copy and Paste TPM Information
   • Step 1
2. At this point, install the new RCDLR.
3. Using a scan tool, navigate to the Copy and Paste TPM Information procedure to paste the stored TPM information using the outline below. Follow the on-screen instructions after selecting Step 2:
   • Vehicle Control Systems
   • Module Setup
   • Remote Control Door Lock Receiver
   • Copy and Paste TPM Information
   • Step 2
4. Program the keyless entry transmitters. Refer to Remote Control Door Lock Transmitter Programming .
5. Setup the new RCDLR:
   1. Select Remote Control Door Lock Receiver under Module Setup in the scan tool Vehicle Control System menu.
   2. Select Setup New RCDLR.
   3. Follow the on-sceen instructions.