Circuit/System Verification
NOTE:
Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize. Refer to J 41413-200
(J 41413-100) operation manual for detailed instructions in Evaporative Emission System Diagnosis
.
- Connect the J 41413-200 nitrogen/smoke hose to the J 41413-311 brass cone adapter. Disconnect the hose at the fuel cap end of the GE-41415-50 . See Special Tools . Connect the J 41413-311 to the disconnected hose on the GE-41415-50 . See Special Tools . Install the GE-41415-50 filler neck end only to the vehicle. See Special Tools .
- Seal the system with a scan tool and use the flow meter on the J 41413-200
(J 41413-100) calibrated to 0. See Special Tools
.51 mm (0.020 in) to determine there is no leak in the EVAP system.
- If a leak is detected, use the J 41413-200 (J 41413-100) to apply smoke to the EVAP system at the filler neck until the leak is located. See Special Tools .