Installation Procedure

Fig 1: Locating EBCM Seals

Courtesy of GENERAL MOTORS CORP.

Fig 2: Locating EBCM

Courtesy of GENERAL MOTORS CORP.

While aligning the brake pressure sensor to the BPMV, carefully install the EBCM (1) to the BPMV.
Do not force the components together.

Fig 3: View Of Lower EBCM Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Fig 4: View Of Upper EBCM Bolts

Courtesy of GENERAL MOTORS CORP.

Fig 5: View Of Brake Fluid Level Indicator Switch & Power Brake Booster Vacuum Sensor Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Position the engine wiring harness upward and connect the power brake booster vacuum sensor electrical connector (1).
Connect the brake fluid level indicator switch electrical connector (2).
Install the engine wiring harness (3) retaining clip to the master cylinder mounting stud.

Fig 6: View Of EBCM Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Position the EBCM electrical connector (1) to the EBCM.
Lower the lever until the locking tabs are fully engaged.
If installing a new EBCM, program the EBCM. Refer to Control Module References .
Perform the Diagnostic System Check - Vehicle .
Observe the brake pedal feel after performing the diagnostic system check. If the pedal now feels spongy, air may have been introduced into the secondary hydraulic circuit of the brake modulator which then may have been introduced into the primary circuit. If the pedal feels spongy, perform the Antilock Brake System Automated Bleed .