Air Flow Meter/Sensor: Service and Repair
MASS AIR FLOW METERREPLACEMENT
NOTE: When disconnecting the battery terminal, initialize the following system after the terminal is reconnected.
- Power window control system
- Sliding roof system
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE MASS AIR FLOW METER
a. Disconnect the mass air flow meter connector.
b. Remove the 2 screws, then remove the mass air flow meter.
3. INSTALL MASS AIR FLOW METER
a. Install the mass air flow meter with the 2 screws.
NOTE: Make sure that the O-ring is not cracked or jammed when installing.
b. Connect the mass air flow meter connector.
4. CONNECT BATTERY NEGATIVE TERMINAL
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)