Inspection Procedure

1. Check that the power window manual UP/DOWN function operates normally.

NG: OTHER PROBLEM 

OK: Go to next step 

1. Turn the ignition switch ON.
2. Operate the power window regulator switch.
3. Check the blinking pattern of the light as shown in the illustration below.

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   Pattern (1) or (3) is displayed	A
   Pattern (2) is displayed	B
   Normal pattern is displayed	C

   Fig 1: Identifying Power Window Regulator Switch

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   Fig 2: Blinking Pattern Of Light

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

B:  Go to step  4

C: REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (PASSENGER SIDE) 

A: Go to next step 

OK: END 

NG: Go to next step 

1. Disconnect the P12 regulator switch connector.
2. Disconnect the P11 power window motor connector.
3. Measure the resistance of the wire harness side connectors.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   P12-5 (VCC) - P11-4 (SSRB)	Below 1 Ω
   P12-3 (PLS) - P11-5 (PLS)	Below 1 Ω
   P12-4 (PLS2) - P11-3 (PLS2)	Below 1 Ω
   P12-8 (SGND) - P11-6 (E)	Below 1 Ω
   P12-5 (VCC) - Body ground	10 kΩ or higher
   P12-3 (PLS) - Body ground	10 kΩ or higher
   P12-4 (PLS2) - Body ground	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

Fig 3: Identifying P12 Regulator Switch And P11 Power Window Motor Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (PASSENGER SIDE)