LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Scion >> 2009 >> tC Standard >> Repair and Diagnosis >> Transmission >> E350 Manual Transaxle >> Transmission Control Cable >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Control Cable: Installation

  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Install the control cable with the 2 bolts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

      Fig 1: Identifying Control Cable Bolts
      G05539590Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the clamp to the control cable.
    3. Install the clamp to the body with the 2 nuts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

      Fig 2: Identifying Clamp To Body Nuts
      G05539591Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the control cable to the control cable bracket, and install 2 new clips.
      5. Fig 3: Identifying Control Cable And Control Cable Bracket With Bolts
      G05539592Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Connect the control cable to the transaxle, and install the 2 washers and 2 clips.
  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Connect the ends of the control cable and install the 2 clips to the shift lever.
    2. Turn the lock nuts of the shift cable 270° counterclockwise, and hold them in that position.
      3. Fig 4: Identifying Lock Nuts Of Shift Cable
      G05539593Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the shift cable while holding them.
    4. Check that the cable are installed securely.
    5. Push in the cable locks of the shift cable and select cable.
    Fig 5: Pushing Cable Locks Of Shift Cable And Select Cable
    G05539594Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 
  4. INSTALL EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  5. INSTALL CENTER AIRBAG SENSOR ASSEMBLY 
  6. INSTALL AIR CONDITIONING UNIT ASSEMBLY  (See INSTALLATION )
  7. INSTALL REAR CONSOLE BOX ASSEMBLY  (See INSTALLATION )
  8. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY UPPER  (See INSTALLATION )
  9. INSTALL CONSOLE PANEL UPPER  (See INSTALLATION )
  10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. PERFORM INITIALIZATION 
    NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal. (a) Perform initialization (see INITIALIZATION ).
  13. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals